3D Print Calibration - Direct Drive Test
So this is the calibration cube I printed with my Ender 3 Pro converted to direct drive with a Bullseye air duct.
It came out pretty good considering how much faster I can put the settings. I'm testing a little at a time though.
This was at 65mm/s with 450 acceleration. Pretty damn fast.
Now to print a new Bullseye duct because I had to superglue this one back together.
Also timelapse settings have been updated to:
30 FPS
Animated
Orbit
I like this. Might keep these settings for now.
▶️ 3Speak
0
0
0.000
Electronic-terrorism, voice to skull and neuro monitoring on Hive and Steem. You can ignore this, but your going to wish you didnt soon. This is happening whether you believe it or not. https://ecency.com/fyrstikken/@fairandbalanced/i-am-the-only-motherfucker-on-the-internet-pointing-to-a-direct-source-for-voice-to-skull-electronic-terrorism