Mini Lathe Amateur, Episode 9, Tailstock Accessories

in #hobbies6 months ago

Hello, hivers! Welcome to my shop!

I'm here today with another episode of Mini Lathe Amateur!

In this episode, I talk about some accessories that are used with the tailstock of the lathe in general, and the 7X10 mini lathe specifically. The tailstock is designed to hold accessories that have a tapered shaft, in this case it is the MT-2 size taper. This is a common taper that is used with lathes, milling machines, and drill presses. There are other sizes in the MT series, the MT-1 is the smallest that I'm aware of. The taper is the same angle with all the MT series, the number determines the size of shaft.

One of the new MT-2 shafts that I recently bought is machined on the large end with a 1/2 inch-20 thread for mounting things such as a drill chuck. This makes it much easier to use a variety of drill bits with the tailstock for drilling a hole in the middle of the piece being turned in the lathe.

Here's my video. It's about 12 minutes long. I try to edit these videos to make them as short as I can without leaving out information that I'm trying to convey in the video.

That's it for this post, I hope you find the video interesting!

amber_yooper.png

Sort:  

Congratulations @amberyooper! You have completed the following achievement on the Hive blockchain and have been rewarded with new badge(s) :

You received more than 6000 HP as payout for your posts and comments.
Your next payout target is 7000 HP.
The unit is Hive Power equivalent because your rewards can be split into HP and HBD

You can view your badges on your board and compare yourself to others in the Ranking
If you no longer want to receive notifications, reply to this comment with the word STOP

Check out the last post from @hivebuzz:

Hive Power Up Day - May 1st 2021 - Hive Power Delegation
Support the HiveBuzz project. Vote for our proposal!