You are viewing a single comment's thread from:

RE: Raspberry Pi Foundation Launches Pi 400

in STEMGeeks4 months ago

For your 3D printer you can also run Klipper on the rPi and get substantial performance improvements over Marlin.

Sort:  

I was going to give Klipper a try when I upgrade the mainboard.

Yes. That's what I did. I upgraded my Ender 3 Pro mainboard to a SKR 1.3 with a rPi 4 running Klipper.

I really should do a post about it.

IMG_2639.JPG

How much faster is it?

At least 100% faster.

I increased print speed from 50 to 100 mm/s in Cura with no ill effect.

I think it could go faster still.

I did a detailed post here: https://stemgeeks.net/hive-163521/@apshamilton/upgrading-the-ender-3-pro-with-klipper-on-raspberry-pi4-skr-1-3-mainboard-and-tmc2209-drivers