RE: Retraction Calibration using SuperSlicer

You are viewing a single comment's thread:

Hello @davidke20, thank you for the advice regarding the magnifying glass, I will surely try to bridge that gap.
Ideally the magnifying glass should not be seen in the macro photo, and I was able to achieve this more desirable effect with longer prints, but these little tiny test prints move so fast, that the proper way to take macros, is to have the camera set up prior to printing, which I did not. 😅

I am learning a lot, thank you for the great feedback and support! 😀



0
0
0.000
0 comments