You are viewing a single comment's thread from:

RE: Retraction Calibration using SuperSlicer

in ThreeD (3D) Printing4 months ago

I'm not going to touch too much at the printing side, but you can try to gap a distance between the magnifier against the camera lens, uses the camera to zoom in to the magnifying glass could be better.

Sort:  

Hello @davidke20, thank you for the advice regarding the magnifying glass, I will surely try to bridge that gap.
Ideally the magnifying glass should not be seen in the macro photo, and I was able to achieve this more desirable effect with longer prints, but these little tiny test prints move so fast, that the proper way to take macros, is to have the camera set up prior to printing, which I did not. 😅

I am learning a lot, thank you for the great feedback and support! 😀