3D Print Calibration - Direct Drive Test

avatar

▶️ Watch on 3Speak


So this is the calibration cube I printed with my Ender 3 Pro converted to direct drive with a Bullseye air duct.

It came out pretty good considering how much faster I can put the settings. I'm testing a little at a time though.

This was at 65mm/s with 450 acceleration. Pretty damn fast.

Now to print a new Bullseye duct because I had to superglue this one back together.

Also timelapse settings have been updated to:

30 FPS
Animated
Orbit

I like this. Might keep these settings for now.


▶️ 3Speak



0
0
0.000
1 comments